AM.CO.ZA (V6-LABEL/A3) V-Auto A3 Automatic Continuously Sheet Feed (ASF) Label Cutting Machine

to be set in the calibration.

2. Put the blank paper into the machine, and move the camera to the blank space for

background reset.

3. Recalibrate

Q: Why is it out of position?

A: 1. When printing, zoom in and out, check whether the size of the picture at the printing

place is consistent with the size set by the computer software.

2. Calibrate "Fine-tune" to fine-tune the offset value.

Q: Why is the lower right accurate, and the rear and left zoomed in or out?

A: 1, first adjust the cutting fine-tuning to the lower right accurately, and then enter the

gear ratio. Test ratio, enter the gear ratio test calibration.

Q: Why does the startup car stop working?

A: 1. Check whether the machine is powered on normally.

2. Check if the metal bar or other wire ends inside the machine are loose and fall off.

3. Replace the metal cable.

Q: Why doesn't the image mark appear on the screen when scanning the mark for the

camera?

A: 1. If the connection line between the camera on the car and the small car plate is loose

or damaged, replace it.

2. Check whether there are occlusions on the camera lens.

3. Replace the metal cable.

Q: Why do U disk files not perform cutting?

A: U disk file must specify the format of the software saving (for example: the U disk file

saved by the built-in CDR/AI plug-in) .

Q: Why does the output not work after connecting the machine?

- 20－ AM.CO.ZA / Sales WhatsApp 060 600 6000 / Support WhatsApp 060 600 7000

20